Description
This two channels Relay Module can be used to control the lighting, electrical and other equipment through the digital IO port. The digital input circuit is optically isolated from the relay, so your controller is protected from voltage spikes and surges. The module is controlled with 5V signal and they are pre-soldered. A logic “LOW” to the control pin will turn the relay ON. Features – 2 independently controlled relays – 5V TTL Digital interface – On-board back EMF protection – Opto-isolated inputs – LED indicator for each channel – Contact Rating (Resistive Load):10A 250VAC Documents: Schematic Dimensions: 50.8(L) x 39.3(W) x 19.3(H)mm Weight: 30g
Features
- 5V 2-Channel Relay interface board, and each one needs 15-20mA Driver Current
- Equiped with high-current relay, AC250V 10A ; DC30V 10A
- Standard interface that can be controlled directly by microcontroller (compatible with Arduino ,Raspberry Pi, 8051, AVR, PIC, DSP, ARM, ARM, MSP430, TTL logic)
- Indication LED’s for Relay output status
Tutorials
Resources
Interface Two Channel Relay Module with Arduino
Robo Admin T –
Great product